MULTIFUNCTION Transmission Range Switch, Adjusting

Special tools and workshop equipment required 

• Setting Gauge T10173

-- Move the selector lever into the "N" position.

-- Do not bend the selector lever cable.

Adjustment Prerequisites 

• The selector lever cable is disconnected from the selector shaft lever.
• The selector shaft is in the "N" position.
• The bolts for the multifunction transmission range switch have been loosened.
• The lever is removed from the selector shaft.

-- Install the setting gauge onto the selector shaft -2- and turn the switch -1- just until the setting gauge locks onto the tab on the switch connection.

Fig 1: Adjustment Tool Attached Onto Shift Rod

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Use the thumb screw -3- to secure the setting gauge to the selector shaft -2-.

-- Tighten the switch bolts -arrows- to 6 Nm.

-- Remove the setting gauge.

-- Further installation is performed in the reverse order of removal. Refer to MULTIFUNCTION TRANSMISSION RANGE SWITCH F125 .