Selector Mechanism, Adjusting: Procedure
- Remove the complete air filter housing if the bracket -A- for securing the gearshift shaft and the securing mechanism for the shift and selector cables are not accessible. Refer to AIR FILTER (CNLA, CRJA)
, AIR FILTER (CZCA, CZDA, CZTA)
, AIR FILTER (CBPA, CKJA)
and AIR FILTER (CPLA, CPPA, CPKA, CPRA)
- Pull the safety mechanism on the cable retainer for the shift cable and the selector cable all the way forward in direction of -arrow 1- and then lock it to the left in direction of -arrow 2-.
Secure the gearshift shaft as follows:
- Push the gearshift shaft down in direction of -arrow 1-.
- While press the gearshift shaft down, rotate the bracket -A- in direction of -arrow 2- upward and simultaneously press it in until it engages in the gearshift shaft.
- Remove the boot with the shifter knob and cover. Refer to → " GEARSHIFT KNOB, REMOVING AND INSTALLING " .
- If equipped, remove the noise insulation.
Secure the gearshift shaft as follows:
- Move the gearshift lever into neutral.
- Guide the -T10027A- through the hole -A- and into the hole -B-.
- Make sure the selector and shift cables -B- are inserted into the retainer -A- without tension.
- Turn the safety mechanism on the cable retainer for the shift cable and selector cable all the way to the right in direction of -arrow 1-.
The spring will push the safety mechanism into the starting position in direction of -arrow 2-.
NOTE:
The bracket -A- must be pressed out of the selector housing as far as the stop and it must face toward the rear.
- Pull the Mandrel out of the holes -A and B-.
- If equipped, install the noise insulation.
- Install the boot with the shifter knob and cover. Refer to → "GEARSHIFT KNOB, REMOVING AND INSTALLING " .
- Make sure the gearshift shaft moves easily.
- If removed, install the complete air filter housing. Refer to AIR FILTER (CNLA, CRJA)
, AIR FILTER (CZCA, CZDA, CZTA)
, AIR FILTER (CBPA, CKJA)
and AIR FILTER (CPLA, CPPA, CPKA, CPRA)