MULTIFUNCTION Transmission Range Switch, Adjusting: Notes

Special Tools And Workshop Equipment Required

Gauge - Multi Function Switch:T10173

-- Move the selector lever into "N".

-- Do not bend the selector lever cable.

Adjustment Requirements:

The selector lever cable is removed from the gearshift lever.
The selector shaft is in "N".
The bolts on the Multifunction Transmission Range Switch -F125- are loosened.
The gearshift lever is removed from the front gearshift shaft.

Adjusting

-- Place the :T10173 on the selector shaft -2- and turn the Multifunction Transmission Range Switch -F125- -1- until the :T10173 locks onto the connector tab on the Multifunction Transmission Range Switch -F125-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

If the connector tab cannot engage into the :T10173 groove, then the transmission is no longer in "N". If this is the case, shift the transmission into "N" using the :T10173 .

-- Secure the :T10173 on the selector shaft -2- with the bolt -3-.

-- Tighten the bolts -arrows- to the tightening specification.

-- Remove the :T10173 .

-- Further installation is performed in reverse order of removal. Refer to MULTIFUNCTION TRANSMISSION RANGE SWITCH, REMOVING AND INSTALLING .