Shorten The Bleed Pipe
:VAS6262A as Follows:
-- Shorten the pipe to dimension -a- so that the bleed pipe on the :VAS6262A will not touch the bottom on some fluid containers.
- Dimension -a- = 210 mm
NOTE:
Dimension -a- is measured starting from the shaft of the :VAS6262A (green surface in the magnified area).
-- Make a mark on the bleed pipe, dimension -a-, and cut it, with for example the :VAS6056/2 .
Special Tools And Workshop Equipment Required
- Torque Wrench 1331 5-50 Nm :VAG1331
- Used Oil Collection and Extraction Unit:SMN372500
- Vehicle Diagnostic Tester
- Shop Crane - Drip Tray:VAS6208
- Oil Filler:VAS6262A
- Oil Filler - Adapter 2:VAS6262/2
- Also Oil Filler - Adapter 6:VAS6262/6 for some fluid containers
Requirements
- The vehicle is level and all hoist mounts are the same height.
- Noise insulation removed.
- The Vehicle Diagnostic Tester is connected.
- To begin working, the oil temperature should not be higher than 45 °C (113 °F).
- Test temperature: 35 to 45 °C (95 to 113 °F)