LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2016 >> Eos 2.0L Eng VIN D >> Repair and Diagnosis >> Engine Performance >> System >> 2.0L - Generic Scan Tool - Engine Code: CCTA >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 09 >> Monitor-Id $3D: EVAP Valve Function Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor-Id $3D: EVAP Valve Function Check

-- Connect the scan tool.

-- Start the engine and run at idle.

-- Select "Mode 6: Check test the results of components that are not continuously monitored".

Select "Monitor-ID 3D".

-- Select the desired "Test-ID".

-- Check specified values at idle.

Test-ID DTC Component or System Min. Max. Additional Information
$80 P0441 Tank vent valve check from % DTEV: Active test Air balance at idle OK, (Normal operation and short test 70). .350 1.999 Refer to DTC P0441 in the DTC summary table. Refer to: DTC TABLES .
$82 - Tank vent valve check from % DTEV: Active test, Oxygen sensor regulator deviating in lean direction (can only test OK), (Normal operation and short test 70). 1 65355 Pass only.

-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch the ignition OFF.

scientia non olet · About LEMON Manuals