Brake Testing With A Standard One-Axle Dynamometer, AWD,

• The testing takes place on a test stand.
• During testing, manual transmission vehicles must in idle and automatic transmission vehicles must be in N.
• Always observe the test stand manufacturer instructions.

-- Drive the vehicle forward onto the rollers.

-- Turn off the engine and wait 2 seconds.

-- Perform the braking test.

-- Start the engine and wait approximately 5 seconds until there is enough vacuum.

-- Drive the vehicle forward until the rear wheel are standing on the rollers.

-- Turn off the engine and wait 2 seconds.

-- Perform the braking test for the rear brakes.

-- Start the engine and wait approximately 5 seconds until there is enough vacuum.