Precaution [08/2013 - ]
WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTE:
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the cable is reconnected.
System Name See Procedure Parking Assist Monitor System Refer to INITIALIZATION [08/2013 - ] Power Trunk Lid System - DOOR CONTROL RECEIVER EXPRESSIONS
- The type of door control receiver used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this information.
Vehicle Specification Part Name in Manual Actual Part Name w/ Side Marker Light Door control receiver Door control and tire pressure monitoring system receiver assembly w/o Side Marker Light Door control receiver Door control receiver
- The type of door control receiver used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this information.
- PRECAUTION WHEN USING TECHSTREAM
- When using the Techstream with the vehicle power switch off, connect the Techstream to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Access. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
- PRECAUTION FOR REGISTRATION
- If replacing any of the following parts, refer to the registration procedures. Refer to REGISTRATION [08/2013 - ]
.
- Certification ECU (smart key ECU assembly)
- Steering lock ECU (steering lock actuator assembly)
- Electrical key transmitter sub-assembly
- ID code box (immobiliser code ECU)
- Power management control ECU
- Main body ECU (multiplex network body ECU)
- If replacing any of the following parts, refer to the registration procedures. Refer to REGISTRATION [08/2013 - ]
.