Selector Mechanism, Disassembling And Assembling: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2018 Audi S8, 2018 Audi A8 Quattro, 2017 Audi S8, 2017 Audi A8 Quattro, and 2016 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Install the Selector Lever Release Button -E681- and the Selector Lever Transmission Range Position Display Unit -Y26-, -3- into the selector lever handle upper section -2-.

-- Install the cover -1-.

-- Install the three bolts -arrows- carefully.

Fig 1: Locating Bolt

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Danger of damaging the components.

The tightening specification for the three screws if very small (-Item 4- OVERVIEW - SELECTOR MECHANISM - List Item:Bolt).

-- Make sure the three clips -1- fit correctly into the bottom of the selector lever handle upper section. Push them in if necessary.

-- Attach the selector lever handle upper section -1- to the selector lever handle lower section -2-.

Fig 2: Identifying Selector Lever Handle Upper Section

Courtesy of AUDI OF AMERICA, LLC

-- Check the selector mechanism. Refer to GEARSHIFT MECHANISM, CHECKING .