Bonded Rubber Bushing In Transmission Support, Removing And Installing
Special tools and workshop equipment required
- Press Plate: VW402
- Press Piece - Multiple Use: VW412
- Press Piece - Bushing - 50mm Diameter: VW432
- Base Block: VW441
- Press Piece - Reverse Gear Syncro: 3296
- Gearbox Carrier Mounting Assembly Tool: T10214
-- Remove the transmission support. Refer to TRANSMISSION SUPPORT AND BRACKET, REMOVING AND INSTALLING .
-- Remove the bonded rubber bushing.
-- Bolt the new bonded rubber bushing to the Gearbox Carrier Mounting Assembly Tool - Thrust Piece: T10214/3 .
-- Install the bonded rubber bushing -A- into the Gearbox Carrier Mounting Assembly Tool - Guide Sleeve: T10214/2 using the Gearbox Carrier Mounting Assembly Tool - Thrust Piece: T10214/3 until the Gearbox Carrier Mounting Assembly Tool - Thrust Piece: T10214/3 is flush with the Gearbox Carrier Mounting Assembly Tool - Guide Sleeve: T10214/2 .
-- Now align the new bonded rubber bushing with the Gearbox Carrier Mounting Assembly Tool: T10214 to the transmission support.
-- To do so, align the bolts -A- or the notch -arrow- on the Gearbox Carrier Mounting Assembly Tool - Thrust Piece: T10214/3 in the center of the holes in the transmission support.
The spaces "x" must be the same.
-- Install the bonded rubber bushing into the transmission support until the Gearbox Carrier Mounting Assembly Tool - Guide Sleeve: T10214/2 can be turned by hand -arrows-.
Do not install the bonded rubber bushing any deeper into the transmission support than the height of the Press Piece - Reverse Gear Syncro: 3296 . Press it in further using the Base Block : VW441 until it stops, if necessary.
-- Install the transmission support. Refer to TRANSMISSION SUPPORT AND BRACKET, REMOVING AND INSTALLING .