Steering Column, Removing And Installing: Notes
Special tools and workshop equipment required
- Torque Wrench 1331 5-50Nm: VAG1331
- Torque Wrench 1410: VAG1410
WARNING:
Note the following before removing the steering column:
Create a sketch showing:
- routing of the electrical wiring harnesses,
- securing the electrical wiring harnesses,
- cable tie locations.
This especially applies to the wiring harness to the Electronic Steering Column Lock Control Module -J764-.
Note the following before installing the steering column:
- Route the electrical wiring harnesses exactly the way they were before removal.
- Secure the electrical wiring harnesses exactly the way they were before removal.
- Reattach all detached or cut cable ties at the same location.
- Make sure the wiring harness to the Electronic Steering Column Lock Control Module -J764- is not pinched and does not come into contact with sharp edges when adjusting the steering column.