REMOVE THE CLIP ON THE Distance Regulation Control Module -J428- "Master", Distance Regulation Control Module 2 -J850- "Slave"

Replace the clip if the adjusting screw -1- was removed during the assembly.

The clip will get damaged while removing it.

The Distance Regulation Control Module -J428- "Master" and Distance Regulation Control Module 2 -J850- "Slave" are removed as well as the nuts for the adjusting screws.

-- Remove the stud bolt -1- in direction of -arrow- using a suitable tool -2- in direction of -arrow-.

Fig 1: Identifying Stud Bolt Removal With Suitable Tool

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place a screwdriver between the hook and the housing.

Fig 2: Place A Screwdriver Between Hook And Housing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Bend the hook with the screwdriver until it breaks off.

-- To prevent the broken hook from getting caught on the housing, remove it from the inside of the clips using needle nose pliers.

-- Remove the clip with needle nose pliers as illustrated.

-- Insert the new clip into the hole in the housing from the left and push it in by hand until it audibly locks.

Fig 3: Insert New Clip Into Hole For Housing From Left Side And Push It In By Hand Until It Audibly Engages

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the adjusting screw making sure it is parallel inside the hole.

-- Install the screw after aligning it.

-- Install the adjusting screw until dimension -a- is reached.

Measure Dimension a on All the Adjusting Screws.

Fig 4: Identifying Dimension -A- To All Studs

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Dimension -a- = 43 mm.

-- Repeat this procedure on all the other clips, if necessary.

-- Install the ACC sensor into the bracket and calibrate the distance regulation. Refer to DISTANCE REGULATION (ACC), CALIBRATING .