11.4.4 Remove the Clip On the Distance Regulation Control Module - J428- "Master", Distance Regulation Control Module 2 - J850- "Slave"

Replace the clip if the adjusting screw -1- was removed during the assembly.

The clip will get damaged while removing it.

• The Distance Regulation Control Module - J428- "Master" and Distance Regulation Control Module 2 - J850- "Slave" are removed as well as the nuts for the adjusting screws.
  • Remove the stud bolt -1- in direction of -arrow- using a suitable tool -2- in direction of -arrow-.
  • Place a screwdriver between the hook and the housing.
  • Bend the hook with the screwdriver until it breaks off.
• Do this to all the hooks.
  • To prevent the broken hook from getting caught on the housing, remove it from the inside of the clips using needle nose pliers.
  • Remove the clip with needle nose pliers as illustrated.
  • Insert the new clip into the hole in the housing from the left and push it in by hand until it audibly locks.
• Make sure the tabs are installed correctly.
  • Install the adjusting screw making sure it is parallel inside the hole.
  • Install the screw after aligning it.
  • Install the adjusting screw until dimension -a- is reached.

Measure Dimension -A- On All The Adjusting Screws. 

Dimension -a- = 43 mm.

• Repeat this procedure on all the other clips, if necessary.
• Install the ACC sensor into the bracket and calibrate the distance regulation. Refer to 11.5 Distance Regulation (ACC), Calibrating