16.7.1 Image Processing Control Module - J851-, Removing And Installing

The Image Processing Control Module - J851- is attached with Velcro® to the interface control module or directly to the bracket under the right front seat, depending on the vehicle equipment level.

Removing: 

• Remove the right front seat. Refer to Body Interior (Front Seats; Seat, Removing and Installing).
• Remove the air duct -1- upward and fold up the carpet -2-.
• Disconnect both connectors -1 and 2-.
• Loosen the Velcro® holding the Image Processing Control Module - J851- -3- to the bracket and remove the control module upward.

Installing 

Install in reverse order of removal. Note the following: