| 1 |
- PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK .
-- Was Complaint verified? |
-- YES:
-- NO:
- GATHER more information from customer about the complaint.
|
| 2 |
- DISCONNECT: Radiator Shutter Motor - V544- harness connector.
- IGNITION: ON.
- CHECK: Radiator Shutter Motor - V544- harness connector terminals 1 to 4 for voltage.
- SPECIFIED VALUE: Battery voltage.
- IGNITION: OFF.
-- Was Value obtained? |
-- YES:
-- NO:
- CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals.
- REPAIR: Faulty wiring or connector.
- REPLACE: Any open fuses.
- GO TO: Step 4
|
| 3 |
- REMOVE: Engine Control Module - J623-. Refer to appropriate repair information.
- CHECK: Radiator Shutter Motor - V544- harness connector terminal x to the Engine Control Module - J623- harness connector T94 / 70 for resistance.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω).
-- Was Value obtained? |
-- YES:
- REPLACE: Radiator Shutter Motor - V544-. Refer to appropriate repair information.
- GO TO: Step 4.
-- NO:
- CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals.
- REPAIR: Faulty wiring or connector.
- GO TO: Step 4.
|
| 4 |
- Final Procedure
- Perform a road test to verify repair.
- Do any DTC's return:
|
-- YES:
- FAULT DOES RETURN:
- REPLACE: Engine Control Module - J623-. Refer to appropriate repair information.
- FAULT DOES NOT RETURN:
- Check the DTC memory. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY .
- Perform the diagnostic procedure for that DTC.
-- NO:
- Repair is complete. Generate readiness code. Refer to READINESS CODE .
- Return vehicle to Customer.
|