LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2015 >> Passat TDI SE, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L - Engine Assembly - Engine Code: CVCA >> 10 Engine Assembly >> Removal And Installation >> Transmission Mount >> Installing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Mount: Installing

Install in reverse order of removal. Note the following:

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

-- Secure the transmission support to the longitudinal member.

CAUTION:

Risk of damaging threads in transmission support by inserting bolts crooked.

  • The transmission support and the transmission mount support arm must be absolutely parallel to each other before installing bolts. Push the transmission up using a floor jack if necessary.
  • Only remove the Engine Support Bridge10-222A when bolts for subframe mount are tightened to tightening specification.

-- Pull the transmission up using the spindle on the engine support bridge until the transmission support touches the transmission mount support arm.

-- Check the adjustment of the assembly mounts, refer to SUBFRAME MOUNT, CHECKING ADJUSTMENT .

-- Remove the Engine Support Bridge 10-222A from the engine.

scientia non olet · About LEMON Manuals