Emissions Test Specified Data Input: Notes

Specification data may be entered differently:

NOTE:

In order to be able to use ELSA web service, the Emissions Testing Station used for the emissions test must be integrated in the workshop network.

When using ELSA Web service, the vehicle specification data is automatically transferred via the network into the appropriate form.

Manual Emissions Test Specified Data Input:

NOTE:

All test requirements and data required for the emissions test can be found on Data sheets for exhaust emission test for the corresponding engine.

-- Follow the instructions on the display for manual data input.

-- Enter the indicated values on the emissions testing data sheet "test values for the emissions test" on the display in the following sequence:

Test RPM (Idle Speed)
Warm-Up Time for Catalytic Converter
Engine Temperature
Increased Idle Speed
CO Content at Increased Idle
Oxygen in Increased Idle
Idle Speed
Select the upstream oxygen sensor type, either "snap sensor" or "broadband sensor".
Heated Oxygen Sensor Value

Emissions test specified data input as bar code:

-- If the emissions test specified data is available as a bar code, scan in the bar code of emissions testing data sheet using bar code reader.

Screen containing all required data appears on the display.