Guidelines For Clean Working Conditions

Even Small Pieces of Debris Can Cause Faults. Therefore When Working on the Fuel Supply, Injection System and Turbocharger, Pay Careful Attention to the Following Rules of Cleanliness:

• Before loosening, the connection points and surrounding areas must be cleaned thoroughly with engine or brake cleaner, and then the cleaned area must be thoroughly dried.
• Immediately seal off any open lines and connections with clean plugs taken from the Engine Bung Set:VAS6122  , for example.
• Place removed parts on a clean surface and cover them with lint-free cloths.
• Carefully cover or seal opened components if repairs are not performed immediately.
• Only install clean parts: remove the replacement parts from their packaging just before installing them. Do not use any parts that have been kept out of packaging (for example, in a toolbox).
• Supplied transport and protective packaging and sealing cover should only be removed immediately before installing.
• If the system is open, do not work with compressed air and do not move the vehicle.
• Make sure no fuel gets onto the fuel hoses. If necessary, the fuel hoses must be cleaned again immediately.
• Protect any disconnected connectors from dirt and moisture, and only connect them when they are completely dry.