Selector Mechanism, Disassembling and Assembling: Disassembling
WARNING: This page is about a different variant/trim than selected.
- Remove the selector mechanism. Refer to → " SELECTOR MECHANISM, REMOVING AND INSTALLING " .
- Bend up the tabs -arrows- on the shift mechanism base plate using a screwdriver and remove the base plate. Only the straps on the left side of the base plate are shown in the illustration.
- Remove the seal from the shift housing.
- Remove the shift cable and the selector cable from the shift housing. Refer to → GEARSHIFT CABLE AND SELECTOR CABLE, REMOVING AND INSTALLING "
"
.
- Lift the upper end -A- of the pressure spring over the tab on the selector bracket.
- Using a screwdriver, press bearing shell notches -arrows- in direction of shift lever guide bearing; break of notches if necessary.
- Pry out bearing shell -A- with shift lever guide -B- from selector housing.
- Then press bearing shell off shift lever guide bearing and remove.
- Pay attention to the guides -A- in the next work procedure.
- The guides must not break off.
- Lift the bottom end -arrow 1- of the pressure spring onto shoulder on selector bracket.
- Now raise shift lever guide up as far as stop and remove ball studs from selector bracket -arrow 2-.
- Turn the shift lever guide in direction of -arrow 1-.
- The pins -arrow 2- must be in the shift housing opening.