April 5, 2026: LEMON Manuals is launched! Read the announcement.

Selector Mechanism, Disassembling and Assembling: Assembling: Notes

WARNING: This page is about a different variant/trim than selected.

CAUTION: The lower side of the spring -arrow 1 -can spring down uncontrolled from the selector bracket shoulder during subsequent handling.

Push the lower end carefully from the selector bracket shoulder.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The spring sides then twist "diagonally" with a loud noise.

Release the tension on the ends -A and B- by turning both ends to the right.

the ends -A and B- must face in the opposite direction.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Install the shift lever guide into the shift housing.

The pins -arrow 1- are still located in the shift housing opening.

Turn the shift lever guide in direction of -arrow 2- until the ball stud -A- is above the opening in the shift housing.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Place the shift housing with the shift lever guide into the larger cavity -arrow- in the -T10083-.

NOTE: The selector shaft must be removed in order to insert the gearshift housing with the shift lever guide into the Pressing Support.

G12686821

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The shift lever guide must project out of selector housing as far as stop.

NOTE: The selector bracket is only partially shown to provide a better illustration.

Insert the end -A- of the pressure spring into the guide from the top.
Pull the spring end -B- downward and insert it next to the guide (toward the ball head).

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Pay attention to the guides (→ upper illustration) in the next work procedure.
They must not break off.

Carefully remove the shift housing and shift lever guide from the -T10083-.
Move the selector bracket all the way to the rear opposite mounting holes for shift and selector cable in direction of -arrow 1-.
Grease the ball stud.
Press the ball stud into the selector bracket -arrow 2-.

The guides -A- and the tabs -B- must not be damaged.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Place the shift housing with the shift lever guide into the larger cavity -arrow- in the -T10083-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The shift lever guide must project out of selector housing as far as stop.

Pry the upper end -A- of the pressure spring over the pin on the selector bracket.

Use a new bearing shell -B-.

Grease the bearing shell and the shift lever guide bearing.
Press the bearing shell all the way onto the shift lever guide bearing.
Remove the shift housing from the -T10083-.
Insert the bottom end -C- of the pressure spring into the guide.
Pry the upper end -A- of the pressure spring over the pin on the selector bracket.
Push the bearing shell into the shift housing -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

All retaining tabs must engage.

If equipped install the shift lever in the shift housing.
Secure the shift cable and selector cable on the shift housing with lock washers -2- and -3-.
Install the shift cable -1- on the gearshift lever and selector cable -4- on the selector lever inside the shift housing.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.