Abs Mark 60 EC (Abs/EDL/ASR/Esp) Assembly Overview
WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, 2011 Volkswagen Jetta, and 2010 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Assembly Overview: ABS Mark 60, ABS, EDL, ASR And ESP, From Calendar Week 22.2008
- ABS Control Module (w/EDL) -J104-
- Removal and installation, refer to CONTROL MODULE AND HYDRAULIC UNIT, REMOVING .
- Bolt, 2 Nm + 0.8 Nm
- Use new bolts.
- ABS Hydraulic Unit -N55-
- Removal and installation, refer to CONTROL MODULE AND HYDRAULIC UNIT, REMOVING .
- Brake Line, 14 Nm
- Master brake cylinder/primary piston circuit to hydraulic control unit.
- Identification: ø 6.5 mm and tube fitting with thread M 12 x 1.
- Brake Line, 14 Nm
- Master brake cylinder/secondary piston circuit to hydraulic unit.
- Identification: ø 6.5 mm and tube fitting with thread M 12 x 1.
- Brake Line, 14 Nm
- To left front brake caliper.
- Identification: ø 5.25 mm and tube fitting with thread M 10 x 1.
- Brake Line, 14 Nm
- To right front brake caliper.
- Identification: ø 5.25 mm and tube fitting with thread M 12 x 1.
- Brake Line, 14 Nm
- To left rear brake caliper.
- Identification: ø 5.25 mm and tube fitting with thread M 12 x 1.
- Brake Line, 14 Nm
- To right rear brake caliper.
- Identification: ø 5.25 mm and tube fitting with thread M 10 x 1.
- Brake Booster
- Removal and installation, refer to BRAKE BOOSTER .
- Bracket
- After installing, make sure it fits properly.
- Bolt, 8 Nm
- Rubber Insulation
- Bolt, 8 Nm
- Bracket
- Rubber Insulation
- When installing the mount, make sure the rubber insulation does not push out of the bracket.
- Nut, 20 Nm
- Heat Shield
- Nut, 8 Nm