Steering System Assembly Overview
WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, 2011 Volkswagen Jetta, and 2010 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Electrical Wiring
- Universal Joint
- Bolt
- 30 Nm
- Always replace if removed.
- Bolt
- 6 Nm
- Self-tapping
- Shield
- Steering Gear
- With Power Steering Control Module -J500-.
- With Electromechanical Power Steering Motor -V187-.
- With Steering Angle Sensor -G85-.
- With Steering Torque Sensor -G269-.
- Can be tested in Guided Fault Finding using the Vehicle Diagnostic Tester.
- Removing and installing, refer to STEERING GEAR .NOTE:
Correct any faults stored in the DTC memory before replacing the steering gear using Vehicle Diagnostic Tester.
- Left Wheel Bearing Housing
- Nut
- 20 Nm + 90° turn
- Self-locking
- Always replace if removed.
- Bolt
- 50 Nm + 90° turn
- Always replace if removed.
- Subframe
- Right Wheel Bearing Housing