IPOD BASEPLATE -R192-, Troubleshooting

WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, 2011 Volkswagen Jetta, and 2010 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Hand-Held Multimeter V.A.G 1526C
Connector Test Kit V.A.G 1594C

The iPod baseplate does not have OBD.

The voltage supply can be checked at the connector.

Test Conditions

iPod OK, refer to the Operating Instructions.
iPod RESET performed, refer to the Operating Instructions.
Fuse OK.
Radio/RNS no faults using Vehicle diagnostic tester.

Procedure

-- Remove the iPod baseplate. Refer to IPOD BASEPLATE -R192- .

-- Disconnect the connector under the iPod baseplate.

-- Turn on the radio/RNS

-- Measure the voltage between contacts 3 and 6 as well as between contacts 3 and 8 on the wiring harness connector using V.A.G 1526C and the cables from the V.A.G 1594C.

Specified value: approximately 12 V.

-- Turn off the radio/RNS.

Voltage values not OK:

-- Check the wire connection between the radio and the iPod baseplate according to the wiring diagram.

Voltage values OK:

-- Replace the iPod baseplate.