Windshield Wiper System Overview
WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, 2011 Volkswagen Jetta, and 2010 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- 20 Nm
- Windshield Wiper
- Removal and installation, refer to JOINT-FREE WIPER BLADES, FRONT .
- Adjusting park position, refer to WINDSHIELD WIPER BLADES, ADJUSTING PARK POSITION .
- Wiper Arms
- Removal and installation, refer to WINDSHIELD WIPER ARMS .
- Screw
- 8 Nm
- Wiper Frame With Linkage
- Removal and installation, refer to DISCONNECT THE CONNECTOR -1- .
- Windshield Wiper Motor -V- with Wiper Motor Control Module -J400-
- For removing and installing wiper frame, refer to WINDSHIELD WIPER MOTOR -V- .
- Wiper Motor Control Module -J400- Coding/Deactivating the APP Function, refer to WIPER MOTOR CONTROL MODULE -J400-, DEACTIVATING APP FUNCTION .
- Rubber Grommet In The Bulkhead
- Note installation instructions, refer to WHILE INSTALLING, SECURING PIN -2- OF WIPER FRAME MUST BE INSERTED INTO GROMMET -1- ON BULKHEAD .
No Illustration
- Windshield wiper motor -V- bolts to the wiper frame with linkage - 8 Nm
- Windshield wiper motor crank to windshield wiper motor shaft: 18 Nm