Abs Mark 60 EC (Abs/Eds/ASR/Esp) Overview
WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, and 2011 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- ABS Hydraulic Unit -N55-
- Removing and Installing, refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55- .
- Disconnect the ABS Control Module -J104- from the ABS Hydraulic Unit -N55-, refer to ABS Control Module -J104-, SEPARATING FROM THE ABS Hydraulic Unit -N55-, ABS MARK 60 EC ABS/EDL/ASR/ESP .
- ABS Control Module -J104-
- Removing and Installing, refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55- .
- Disconnect the ABS Control Module -J104- from the ABS Hydraulic Unit -N55-, refer to ABS Control Module -J104-, SEPARATING FROM THE ABS Hydraulic Unit -N55-, ABS MARK 60 EC ABS/EDL/ASR/ESP .
- Bolt
- 2 Nm +/- 0.8 Nm
- Quantity: 4
- Always replace if removed.
- Brake Line
- 14 Nm
- To the left front brake caliper.
- Identification: 5.25 mm diameter and tube fitting with a M12 x 1 thread.
- Brake Line
- 14 Nm
- ABS Hydraulic Unit -N55- for the master brake cylinder/primary piston circuit.
- Identification: 6.5 mm diameter and tube fitting with a M12 x 1 thread.
- Brake Line
- 14 Nm
- To the right front brake caliper.
- Identification: 5.25 mm diameter and tube fitting with a M12 x 1 thread.
- Brake Line
- 14 Nm
- ABS Hydraulic Unit -N55- for the master brake cylinder/secondary piston circuit.
- Identification: 6.5 mm diameter and tube fitting with a M12 x 1 thread.
- Brake Line
- 14 Nm
- Master brake cylinder/primary piston circuit for the ABS Hydraulic Unit -N55-.
- Identification: 6.5 mm diameter and tube fitting with a M12 x 1 thread.
- Brake Line
- 14 Nm
- Master brake cylinder/secondary piston circuit for the ABS Hydraulic Unit -N55-.
- Identification: 6.5 mm diameter and tube fitting with a M12 x 1 thread.
- Brake Booster with Master Brake Cylinder
- See REMOVAL AND INSTALLATION .
- Brake Booster, Removing and Installing, refer to BRAKE BOOSTER .
- Brake Master Cylinder, Removing and Installing, refer to MASTER BRAKE CYLINDER .
- Brake Line
- 14 Nm
- To left rear brake caliper/brake cylinder.
- Identification: 5.25 mm diameter and tube fitting with a M12 x 1 thread.
- Brake Line
- 14 Nm
- To the right rear brake caliper/brake cylinder.
- Identification: 5.25 mm diameter and tube fitting with a M12 x 1 thread.
- Hex bolt
- 8 Nm
- Rubber Insulation
- Bracket
- After installing, make sure it fits properly.
- Bolt
- 8 Nm
- Quantity: 3
- Nut
- 8 Nm
- Quantity: 2
- Bracket
- Rubber Insulation
- Do not press the rubber bushings out of the bracket when installing the mount.