Service Interval Display: Coding At Delivery Inspection (For USA And CANADA)

WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, and 2011 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Switch on the ignition.

-- Touch the "GUIDED FAULT FINDING" button/field on the screen.

NOTE:

If the displays indicated in the procedure are not shown on the display, refer operating instructions for Vehicle Diagnostic Tester or Vehicle Diagnostic Tester.

-- Select the following one after the other:

Brand
Type
Model year
Engine code

-- Confirm the VIN.

If the vehicle identification procedure was performed correctly, press > button for confirmation.

-- Select the following one after the other:

Body
Electrical Equipment
01 - On Board Diagnostic (OBD) capable systems
"Instrument cluster" -ARROW-.

Fig 1: Diagnosis System Display: 17 - Instrument Panel Insert
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Instrument cluster functions
"Adapt Service Interval Display".

NOTE:

Check which intervals are set.

Intervals must be set or recoded for first oil change service at 5, 000 miles/8, 000 km.

-- Perform Adaptation according to instructions from "GUIDED FAULT FINDING".

Note for vehicles from MY 07:

NOTE:

The following applies to USA and Canada vehicles:

Channel 50: 50 (= 5, 000 miles) for USA

Channel 50: 80 (= 8000 km) for CDN

Channel 51: 372 (= 372 days) for USA and CDN

When coding to QG0 or QG2: Channels 42 + 49 are not available and are replaced with channels 50 + 51.

Furthermore, when coding QG0, QG2, channels 43, 44 and 49 are deactivated

Ending the adaptation:

Indicated on display:

Fig 2: Identifying "Go To" Button On Scan Tool Display

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the Go to button -arrow- on display.

Indicated on display:

Fig 3: Identifying "Exit" Button On Scan Tool Display

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the End button -arrow- on the display.

-- Turn off the ignition and disconnect the diagnostic connector.