Cell Phone Operating Electronics Control Module -J412-, UMI

The Cell Phone Operating Electronics Control Module -J412- is attached to the glove compartment.

Removing 

-- Switch off the ignition and all electrical consumers and remove the ignition key.

-- Disconnect any devices connected to the Cell Phone Operating Electronics Control Module -J412-.

-- Remove the glove compartment, refer to Storage Compartments and Covers .

-- Release and disconnect the connector from the Cell Phone Operating Electronics Control Module -J412-.

-- Remove the screws -3- and remove the Cell Phone Operating Electronics Control Module -J412- -1- with the bracket -2-.

Fig 1: Identifying Cell Phone Operating Electronics Control Module

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bracket -2- from the Cell Phone Operating Electronics Control Module -J412- -1-.

Installing 

Install in reverse order of removal.

Tightening Specifications 

• Refer to COMPONENT LOCATION, UMI 

The Cell Phone Operating Electronics Control Module -J412- is installed in the center console.

Removing 

-- Switch off the ignition and all electrical consumers and remove the ignition key.

-- Disconnect any devices connected to the Cell Phone Operating Electronics Control Module -J412-.

-- Remove the rear center console trim, refer to Center Console, Comfort and Highline .

-- Release the retainers -2- on the bracket for the Cell Phone Operating Electronics Control Module -J412- -1-.

Fig 1: Identifying Cell Phone Operating Electronics Control Module

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull the Cell Phone Operating Electronics Control Module -J412- -1- upward out of the center console with the bracket and trim -arrow- until the connector is accessible.

-- Release and disconnect the connector from the Cell Phone Operating Electronics Control Module -J412-.

-- Remove the bolts -1-.

Fig 2: Identifying Cell Phone Operating Electronics Control Module Connector Overview

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the trim -2- in the direction of -arrow A- from the bracket -3-.

-- Remove the Cell Phone Operating Electronics Control Module -J412- -4- from the bracket -3- in the direction of -arrow B-.

Installing 

Install in reverse order of removal.

Tightening Specifications