Multimedia System Control Module -J650-, UMI
The Multimedia System Control Module -J650- is installed in the center console.
Removing
-- Switch off the ignition and all electrical consumers and remove the ignition key.
-- Disconnect any devices connected to the Multimedia System Control Module -J650-.
-- -Remove the rear center console trim, refer to Removal and Installation .
-- Release the retainers -2- on the bracket for the Multimedia System Control Module -J650- -1-
-- Pull the Multimedia System Control Module -J650- -1- with the bracket and trim upward from the center console -arrow- until the connector is accessible.
-- Release and disconnect the connector from the Multimedia System Control Module -J650-.
-- Remove the screws -1-.
-- Remove the trim -2- in direction of -arrow A- from the bracket -3-
-- Remove the Multimedia System Control Module -J650- in direction of -arrow B- from the bracket -3-.
Installing
Install in reverse order of removal.
Tightening Specifications
| Component | Tightening Specification |
|---|---|
| Screw for trim to bracket | 2 Nm |
The Multimedia System Control Module -J650- is installed in the center console.
Removing
-- Switch off the ignition and all electrical consumers and remove the ignition key.
-- Remove any devices connected to the Multimedia System Control Module -J650-.
-- Remove the rear center console trim, refer to Center Console, Comfort and Highline .
-- Release the catches -2- on the bracket for the Multimedia System Control Module -J650- -1-.
-- Pull the Multimedia System Control Module -J650- -1- with the bracket and trim upward from the center console -arrow-, until the connector is accessible.
-- Release and disconnect the connector from the Multimedia System Control Module -J650-.
-- Remove the bolts -1-.
-- Remove the trim -2- in the direction of -arrow A- from the bracket -3-.
-- Remove the Multimedia System Control Module -J650- -4- in the direction of -arrow B- from the bracket -3-.
Installing
Install in reverse order of removal.
Tightening Specifications
| Component | Tightening specification |
|---|---|
| Screw for trim to bracket | 2 Nm |