Engine, Installing: Procedure

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

Replace the self-locking nuts and bolts, gaskets, seals and O-rings after removing.

The hose connections as well as air duct pipes and hoses must be free of oil and grease before installing.

Secure all hose connections with hose clamps that match the ones used in series production..

During installation, all cable ties must be installed at the same location.

-- Install the intermediate plate. Refer to Procedure .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If the alignment sleeves -A- for centering the engine and transmission are missing inside the cylinder block, then install the alignment sleeves.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

The illustration shows a vehicle with a manual transmission.