Common Specs & Procedures
SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | REFRIGERANT R134A PHYSICAL DATA | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | Hex head bolt: 200 Nm + 180° turn Twelve-point bolt with ribs is 70 Nm + 90° turn Twelve-point bolt without ribs is 200 Nm + 180° turn |
||
| Rear | 200 Nm + 90° turn | ||
| Battery | 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM WITH Brake Charger/Bleeder Unit VAS 5234 OR V.A.G 1869 |
||
| Disc Brakes | FRONT BRAKES | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS
Hydraulic Components FASTENER TIGHTENING SPECIFICATIONS Mechanical Components |
||
| Charging | |||
| Generator | N/A | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | Ribbed Belt | ||
| Belt Routing | See fig. 26 under Installing | ||
| Engine Cooling | |||
| General Service Specifications | Refer to the approrpiate FLUID CAPACITY TABLES information. | ||
| Radiator Cap Pressure | 1.4 to 1.6 bar | ||
| Thermostat R & I | COOLANT THERMOSTAT | ||
| Water Pump R & I | COOLANT PUMP | ||
| Engine Mechanical | |||
| Compression | COMPRESSION PRESSURE, CHECKING | ||
| Oil Pressure | 1.2 to 1.6 bar (17.40 to 23.20 psi) At 2000 RPM 2.0 to 4.5 bar (29.00 to 65.26 psi) |
||
| Overhaul | 10 ENGINE ASSEMBLY | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||
| Flywheel/Flex Plate Torque | 60 Nm + an additional 90° (1/4) turn | ||
| Fuel System | |||
| Pressure Specification | The fuel injection system is separated into a high pressure side, where the pressure is a maximum of approximately 120 bar (1, 740 psi) and a low pressure side, where the pressure is approximately 6 bar (87.02 psi) | ||
| Fuel Pressure Test Procedure | Fuel Pressure Sensor -G247-, CHECKING | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Coil-On-Plug | ||
| Ignition Wires (Routing) | Coil-On-Plug | ||
| Spark Plug | TECHNICAL DATA AND SPARK PLUGS | ||
| Starting | |||
| Starter | Starter Overview | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | Wheel Alignment Specified Values | ||
| Torque | Fastener Tightening Specifications | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 120 Nm | ||