Selector Mechanism: Removing

-- Move the selector lever into "P".

-- Remove the selector lever handle SELECTOR LEVER HANDLE . Disconnect the connector -2- from the cover while doing this.

Fig 1: Identifying Electrical Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the center console. Refer to Removal and Installation .

-- Disconnect the connector -1- from the selector mechanism to the vehicle wiring harness.

-- Remove the engine cover by gently pull the engine cover up, and the air filter. Refer to AIR FILTER HOUSING .

-- Disconnect the cable by squeezing in the -direction of arrows 1- and then remove it from the cable mounting bracket in the -direction of arrow 2-.

Fig 2: Identifying Cable Disengaged And Removed From Mounting Bracket

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Do not use pliers because the tabs on the cable bracket could break off.

Do not bend or kink the selector lever cable.

-- Pry the cable -1- off the selector lever -3-, using for example, a wrench -2-.

Fig 3: Identifying Selector Lever Cable, Lever/Selector Shaft And 10 mm Open-End Wrench

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the selector lever cable -1- from the bracket -arrow- on the transmission.

Fig 4: Identifying Clip Securing Selector Lever Cable

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lift the vehicle.

-- Remove the front and rear tunnel braces from the body. Refer to Description and Operation .

CAUTION:

There is a danger of causing damage to the decoupling element.

Do not bend the decoupling element more than 10°.
Do not load the decoupling element.
Do not damage the wire mesh on the decoupling element.

-- Remove the front exhaust pipe with the catalytic converter. Refer to Catalytic Converter With Front Exhaust Pipe .

-- Disconnect the center and rear mufflers from the retaining straps and tie them to the body with wire. Refer to Rear Muffler .

-- Remove the center tunnel heat shield under the selector mechanism.

NOTE: A second technician is required under the vehicle to remove the selector mechanism.

-- Remove the nuts -arrows- in the vehicle interior.

Fig 5: Identifying Selector Mechanism & Bracket

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bracket -A-, if equipped.

-- Remove the selector mechanism -B- with the selector lever cable and selector housing downward.

NOTE:

The selector mechanism can also be removed without having to remove the selector housing.

To do this, remove the four bolts. See -item 4-.

Fig 6: Identifying Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Remove then the selector mechanism with the selector lever cable inside the passenger compartment in -direction of arrow-.

Fig 7: Identifying Removal Of Selector Mechanism

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The selector mechanism is available only together with the selector housing and selector lever cable.

Install in reverse order of removal.

NOTE:

Do not bend or kink the selector lever cable.

Do not lubricate the selector lever cable.

-- Push the selector lever cable carefully onto the selector lever and insert it into the cable bracket.

-- Install the heat shield under the shift mechanism.

-- Reconnect exhaust system making sure it is not under stress. Refer to Exhaust System, Installing Without Tension .

-- Install the front and rear tunnel braces on the body. Refer to Description and Operation .

-- Install the center console. Refer to Removal and Installation .

-- Install the selector lever handle. Refer to Installing .

-- Adjust the selector lever cable. Refer to Adjusting .

-- Check the selector mechanism. Refer to GEARSHIFT MECHANISM, CHECKING .

-- Install the engine cover by gently pushing the engine cover down, and the air filter. Refer to AIR FILTER HOUSING .