Information Electronics Control Module 1, Removing And Installing: Removing:
-- If the control module is replaced, select the "Replacement" function for the appropriate control module in "Guided Fault Finding".
Connect the Vehicle Diagnostic Tester to do this.
Perform the Following Steps:
-- Turn off the ignition and all electrical equipment.
-- Remove the glove compartment. Refer to STORAGE COMPARTMENTS, COVERS AND TRIM .
-- Release and disconnect the connectors -2- through -7-.
Disconnect the fiber-optic cable -1- from the Information Electronics Control Module 1 and attach the Fiber-Optic Repair Set - Connector Protective Caps:VAS6223/9 to the disconnected fiber-optic cable connection.
Fiber-optic cable is very delicate!
The fiber-optic cable must not be kinked or significantly bent!
The bending radius must not be less than 25 mm.
A kinked fiber-optic cable is no longer usable, data transfer via kinked fiber-optic cable is faulty!
Please do not remove the protective caps from the ends of the fiber-optic cable until the fiber-optic cable is connected to the intended unit.
-- Insert the Radio Removal Tools:T10057 into the release slots -arrows- until they engage.
-- Pull the information electronics control module 1 via the gripping rings of the release tools in the direction of -arrow- out of the installation frame.