Power Steering Pump, Removing And Installing: Installing: Notes

Install In Reverse Order Of Removal. Note The Following:

NOTE:

Replace the gaskets and seals.

Before installing the new power steering pump on the intake side, fill the Hydraulic Fluid and install it by hand until oil drains out on the high pressure side.

Hose supports and hoses must be free of oil and grease before installation.

Secure all hose connections with new hose clamps. Refer to the Parts Information.

-- Install the power steering pump, tightening the front bolts first.

-- Install the ribbed belt, and then check ribbed belt alignment. Refer to RIBBED BELT, REMOVING AND INSTALLING .

Fig 1: Identifying Ribbed Belt Components With An Additional Idler Pulley

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Make sure the ribbed belt fits correctly in the belt pulley.

1 -Belt pulley - generator

2 - Idler Roller

3 - Idler Roller

4 - Belt pulley - coolant pump

5 - Belt pulley - power steering pump

6 - Ribbed belt pulley - A/C compressor

7 - Tensioning roller

8 -Belt pulley - crankshaft

-- Bleed steering system. Refer to POWER STEERING SYSTEM, BLEEDING .

-- Check the hydraulic fluid level and fill if necessary. Refer to appropriate service information.

-- Check the steering system for leaks. Refer to STEERING SYSTEM, CHECKING FOR LEAKS .