Engine, Installing

WARNING: This page is about a different variant/trim than selected.

-- Raise the drivetrain up until it comes into contact with the body using the Scissor Lift Table:VAS6131 . Be careful of the installed Assembly Carrier Locating Pins:T10300 when doing this.

-- Attach the subframe to the vehicle. Refer to SUBFRAME .

-- Reconnect all connections, lines, hoses and connectors that were disconnected for the removal procedure.

-- On hybrid vehicles, it is very important the contact surfaces on the potential equalization cable are clean and have no grease on them. Clean the contact surfaces. Refer to HIGH VOLTAGE SYSTEM GENERAL WARNINGS .

-- Install the plenum chamber cover. Refer to PLENUM CHAMBER BULKHEAD .

-- Install the right and left wiper arms. Refer to WINDSHIELD WIPER SYSTEM .

-- Connect the A/C lines. Refer to REFRIGERANT CIRCUIT .

-- Refill the A/C system with refrigerant. Refer to REFRIGERANT CIRCUIT .

-- Fill the power steering fluid. Refer to appropriate service information.

-- Fill with coolant for the high temperature coolant circuit. Refer to COOLANT, DRAINING AND FILLING, HIGH TEMPERATURE CIRCUIT .

-- Fill with coolant for the low temperature coolant circuit. Refer to COOLANT, DRAINING AND FILLING, LOW TEMPERATURE CIRCUIT .

-- If necessary, fill with engine oil.

-- Connect the battery. Refer to BATTERY .

-- Re-energize the high voltage system. Refer to HIGH VOLTAGE SYSTEM GENERAL WARNINGS .

-- Bleed the clutch. Refer to HYDRAULIC SYSTEM, BLEEDING .

-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, REMOVING AND INSTALLING, VEHICLES THROUGH 05/2012 .

-- Fill the ATF. Refer to ATF LEVEL, CHECKING AND FILLING .

-- Connect the Vehicle Diagnostic Tester.

-- Perform a vehicle system test. Refer to Vehicle Diagnostic Tester in "Guided Fault Finding" .

-- End the vehicle system test in such a way that possibly existing DTC entries are automatically erased.

-- Calibrate the electro-drive drive motor. Refer to Vehicle Diagnostic Tester in "Guided Functions" .

-- Create the readiness code with a road test.

Always observe all safety precautions when performing the road test.

-- Perform another vehicle system test and correct any faults.

NOTE:

If, during the road test, it is discovered that the steering wheel is not exactly straight when driving in a straight line, then perform an axle alignment. Refer to appropriate service information. .