Cellular Telephone And Two-Way Radio Transmitter And Receiver Unit Overview
- 1 -
Positive Connection
- Red wire with suitable connection.
- 2 -
To Terminal 15a
- Connection to terminal 15a. Refer to appropriate System Wiring Diagram Information.
- Ensure wire is protected by fuse.
- Fuse maximum 15 amps.
- 3 -
Antenna Ground
- Ensure correct ground connection to body.
- Antenna location must be treated with suitable corrosion protection.
- 4 -
Transceiver Antenna
- Installation locations, refer to ANTENNA INSTALLATION LOCATIONS .
- 5 -
Shielded Antenna Wire
- Wire with coaxial connector.
- 6 -
Telephone or Two-Way Radio Transceiver
- 7 -
Wiring Harness
- Voltage supply positive via red wire, 2.5 mm2 cross section.
- Voltage supply negative via brown wire, 2.5 mm2 cross section.
- If necessary, wire to terminal 15a via black wire 1.5 mm 2 cross section.
- 8 -
Fuse Holder
- Install next to battery.
- 9 -
To Starter
- 10 -
Battery
- Installation location in engine compartment.
- 11 -
Negative Wire
- 12 -
Body Ground