Tightening Specifications
- 1 -
Direction of Travel
- -
Drive Plate to Converter
- 60 Nm
- Quantity: 6, remove and install using the socket SW 15V/175
- -
M12 Bolts
- 80 Nm
- -
M10 Bolts
- 40 Nm
- The bolts are located inside the lower flange
- Arrows -
Alignment Sleeves
- 1 -
Direction of Travel
- -
Drive Plate to Converter
- 60 Nm
- Quantity: 6, remove and install using the socket SW 15V/175
- -
M12 Bolts
- 80 Nm
- -
M10 Bolts
- 40 Nm
- The bolts are located inside the lower flange
- Arrows -
Alignment Sleeves
| Component | Nm |
|---|---|
| Transmission mount bracket to transmission (use new screws) | 40 + 90° (1/4) turn |
| Transmission mount to transmission mount bracket transmission (use new screws) | 60 + 90° (1/4) turn |
| Transmission fluid pipes to transmission | 20 |
| Ground cable to transmission mount bracket | 25 |
| Transmission to engine and bevel box | Refer to BEVEL BOX |
| Bevel box to transmission | |
| Right drive axle heat shield to bevel box | |
| Front flexible disc heat shield | |
| Driveshaft to bevel gear transfer case | Refer to Specifications . |
| Control arm, pendulum support, drive axle | Refer to Special Tools . |
| Wheel bolts | Refer to TIGHTENING SPECIFICATION FOR MOUNTING WHEELS . |