MULTIFUNCTION Transmission Range Switch F125: Installing

Install in the reverse order of removal. Pay attention to the following:

-- Install the multifunction switch -4- to the selector shaft -6-.

-- Install the bolts -5- for the multifunction switch hand tight.

-- Bend back the hooks -2-.

-- Install the washers -2 and 3- onto the selector shaft -6-.

-- Install the lock washer -2- with the hooks facing up.

-- Install the lock washer -2- with the long narrow guide into the long narrow depression in the selector shaft -6-.

-- Tighten the nut -1- to 7 Nm.

-- Secure the nut -1- by bending the hooks on the lock washer upward -2-.

-- Replace the lock washer if several of the hooks break off while being bent.

-- Adjust the multifunction transmission range switch before installing the selector shaft lever onto the selector shaft. Refer to MULTIFUNCTION TRANSMISSION RANGE SWITCH, ADJUSTING .

-- Place the selector shaft lever -3- onto the selector shaft -4-.

-- Move the selector lever -3- into the "P" position. This means, push the selector lever -3- opposite the drive direction until it stops.

-- Move the selector lever -3- into the "N" position. Push the lever -3- two positions forward in the direction of travel.

-- Install the spring washer -2- and the nut -1- onto the selector shaft -4-.

-- Tighten the nut -1- to 13 Nm.

with 6 Cylinder Engines

-- Install the coolant expansion tank. Refer to Specifications .

-- Connect the battery ground cable. Refer to Removal and Installation .

Continuation for All

-- Check the selector mechanism. Refer to SELECTOR MECHANISM, CHECKING .