Steering Gear, Removing And Installing, RHD: Notes
NOTE:
The generation 2 steering gear is no longer available as a replacement part.
Install a generation 3 steering gear if replacing a steering gear.
In addition to this, the electrical wiring set from the E-box to the steering gear must be changed. It will be included with the new steering gear,
The electrical wiring set is delivered complete together with the wiring for the service interval display.
If the vehicle does not have a service interval display, then the 3-pin connector, not being used, must be sealed off with a Flat Terminal Housing With Contact Seal 1J0 973 803,
Special tools and workshop equipment required
- Torque Wrench 1331 5-50Nm V.A.G 1331
- Torque Wrench 1332 40-200Nm V.A.G 1332
- Engine and Gearbox Jack VAS 6931
- Puller - Ball Joint 3287 A