Electromechanical Parking Brake Control Module: Installing

-- Installation is in reverse order of removal.

When installing electromechanical parking brake control module make sure it is correctly seated in its mounting and is free of stress.

NOTE:

Do not use the nuts to forcibly position the electromechanical parking brake control module.

-- Tighten the nuts to 9 Nm.

-- Code the ABS control module with the => in guided fault finding.

A steering angle sensor -G85-, transverse acceleration sensor -G200-, brake pressure sensor 1 -G201- and longitudinal acceleration sensor -G251- basic setting must be done.

-- Perform basic setting for brake system (electro-mechanical parking brake).

Vehicle Diagnostic Tester, connecting and selecting functions. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING AND SELECTING FUNCTIONS .