Towing Recognition Control Module -J345-

Special tools and workshop equipment required

The towing recognition control module is installed behind the left side trim in the luggage compartment.

Removal

-- Switch off ignition, switch off all electrical consumers and remove ignition key.

-- Remove the left side trim panel inside the luggage compartment. Refer to Removal and Installation .

-- Disengage connectors -2- and disconnect them from Towing Recognition Control Module.

Fig 1: Identifying Towing Recognition Control Module J345 Connectors And Mounting Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

The number of harness connectors on the Towing Recognition Control Module can deviate from the illustration depending on vehicle equipment.

-- Remove the screws -1- and remove towing recognition control module with bracket out of the vehicle.

-- Remove the screws -arrows- and remove towing recognition control module from the bracket.

Fig 2: Identifying Towing Recognition Control Module J345 Mounting Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installation

Install in reverse order of removal, noting the following:

NOTE:

After installing a new towing recognition control module, it must be coded. Refer to TOWING RECOGNITION CONTROL MODULE -J345-, CODING .