Comfort System Central Control Module J393

WARNING: This page is about a different car, the 2011 Volkswagen CC, 2010 Volkswagen CC, and 2009 Volkswagen CC. However, it is still accessible from the selected car via links, so may be relevant.

Depending on equipment, the following control modules are integrated in the Comfort System Central Control Module -J393- :

Anti-Theft Immobilizer Control Module -J362- or Access/Start Control Module -J518-

Additional information:

Refer to Self Study Program No. 416; The Passat CC.

Refer to Self Study Program No. 340; Passat 2006 - Electrical System.

Refer to appropriate SYSTEM WIRING DIAGRAM.

Refer to the Owner's Manual.

General Description

Depending on equipment, the Comfort System Central Control Module performs the following tasks in the vehicle:

Controls central locking system
Front and rear door control module activation
Actuates rear lid unlock
Actuates tank flap release
Actuates anti-theft alarm system. For additional information, refer to ANTI-THEFT ALARM SYSTEM .
Actuates immobilizer. For additional information, refer to IMMOBILIZER .
Actuates access/start authorization system. For additional information, refer to ACCESS/START AUTHORIZATION .

NOTE:

If the Comfort System Central Control Module is to be replaced, the work procedure REPLACING/CODING to read out the codes stored in the module must always be performed.

After replacing the Comfort System Central Control Module, other functions of the Comfort System Central Control Module such as "anti-theft immobilizer", "anti-theft alarm system", "access/start authorization", "tire pressure monitoring system" and central locking system key must also be adapted, depending on vehicle equipment.

For these, start with adaptation of anti-theft immobilizer (ANTI-THEFT IMMOBILIZER CONTROL MODULE J362, ADAPTING ) and then the other, equipment-dependent functions of the Comfort System Central Control Module in any sequence.

The following comfort system functions can be adapted after connecting the vehicle tester, selecting "Guided Fault Finding", pressing the "Go to" button, pressing the "Function/component selection" button and selecting the menu items "Body", "Body Repair Work", "01 - On Board Diagnostic (OBD) capable systems", "Comfort system" and "Functions - comfort system central control module" :

"Factory Mode", deactivating
Adapt "Single door opening"
Adapt "Automatic locking"
Adapt "Automatic unlocking when ignition key is removed"
Adapting "Acknowledgment for unlocking via access/start authorization"
Adapt "Acknowledgment for unlocking via radio remote control"
Adapt "Acknowledgment for unlocking via key switch"
Adapting "Acknowledgment for locking via access/start authorization"
Adapt "Acknowledgment for locking via radio remote control"
Adapt "Acknowledgment for locking via key switch"
Adapt "Acknowledgment for anti-theft alarm system armed"
Adapt "Country selection for the intelligent alarm horn"
Adapt "Vehicle level sensor sensitivity"
Adapt "Sensitivity of interior monitoring"
Adapt "Battery monitoring (sounder)"
Adapt "Comfort operation via remote control"
Adapt "Alarm delay when opening driver door"
"Remote control key", adapting
"Remote control key", checking

DTC Recognition and Display

The Comfort System Central Control Module is equipped with On Board Diagnostics (OBD) which assists troubleshooting.

The "Guided Fault Finding" function is to be used for troubleshooting of the systems as described in VEHICLE DIAGNOSIS, TESTING AND INFORMATION SYSTEMS .