A/C Compressor Sub-Assembly Bracket - Engine Code(S): BLV
WARNING: This page is about a different car, the 2011 Volkswagen CC, 2010 Volkswagen CC, and 2009 Volkswagen CC. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Torque wrench -V.A.G 1331- (or 5-50 Nm equivalent)
NOTE:
The bracket for A/C compressor and ancillary parts can be removed and installed without opening the refrigerant circuit.
Removing the ribbed belt, refer to [For transmission(s) 09M] Removal and Installation
Position of ribbed V-belt, refer to "Ribbed Belt Routing" below.
- Ribbed Belt
- Removing and installing, refer to [For transmission(s) 09M] Removal and Installation .
- Ribbed Belt Pulley - Coolant Pump
- Tensioning Roller
- Sub-Assembly Bracket For Generator and A/C Compressor
- Number on the sub-assembly bracket -038 903 143 AF-.
Removal
-- Loosen A/C compressor, unscrew hex-bolts -9-. Remove A/C compressor from auxiliary component bracket and secure to body with appropriate material (for example, welding wire), refer to Securing A/C Compressor to Body .
-- Remove the screws from the sub-assembly bracket.
Follow the tightening sequence when installing, refer to Sub-assembly Bracket Tightening Sequence .
- Fitting Bolt
- 25 Nm
- Generator
- Dowel Sleeves
- Quantity: 2
- Make sure they fit correctly between the auxiliary component bracket and the A/C compressor.
- A/C Compressor
- Removing and Installing, refer to A/C COMPRESSOR .
- Hex Bolts M8 X 100
- 25 Nm
- Quantity: 3
- Fitting Bolt
- 25 Nm