Instrument Cluster

WARNING: This page is about a different car, the 2011 Volkswagen CC, 2010 Volkswagen CC, and 2009 Volkswagen CC. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Prior to replacing instrument cluster, perform work sequence "Instrument cluster, adaptation/replacing" in order to read out the data stored in the control module. Refer to INSTRUMENT CLUSTER .

Removing

-- Switch off the ignition and all electrical consumers and move the ignition key or start button into the 0 position (preliminary engaged position).

-- Using the height adjuster, move the steering wheel to the lowest position.

-- Remove the trim on the driver side. Refer to Removal and Installation .

-- Remove the instrument cluster trim. Refer to Removal and Installation .

-- Remove the bolts -arrows- from the instrument cluster -1-.

Fig 1: Identifying Instrument Cluster And Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull the instrument cluster back out of the instrument panel while being careful of the connected wires.

-- Tilt the bracket -1- in the -direction of the arrow- and disconnect the connector -2-.

Fig 2: Identifying Clip -1- Secured In -Direction Of Arrow- And Disconnect Connector -2-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installing

Install in reverse order of removal.

-- After installing, test the functions of the instrument cluster.