Selector Lever Cable, Adjusting

WARNING: This page is about a different car, the 2011 Volkswagen CC, 2010 Volkswagen CC, and 2009 Volkswagen CC. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Wrench (5-50 Nm) -V.A.G 1331-

The selector lever cable must be adjusted if:

The selector lever cable was removed from the transmission.
The engine and/or transmission were removed and installed.
The cable itself or the selector mechanism was removed and installed.
Engine/transmission position changes, for example, were installed free of tension.

Adjusting:

-- Move the selector lever into the "P" position.

-- Loosen the adjustment bolt -2- on the selector lever cable -1-.

Fig 1: Identifying Selector Lever Cable At Transmission Side

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Lightly tap the button in the handle forward and backward and make sure to keep the handle in the "P" position.

This locates the cable core in its optimal position.

-- Move the selector shaft lever -3- into the "P" position (push the lever to the rear).

NOTE:

Make sure the transmission is in "P" (parking lock is engaged) if raising the vehicle. It must not be possible to turn the front wheels.

-- Tighten the adjustment bolt -2- to 15 Nm.