Rearview Camera System, Calibrating: Notes
WARNING: This page is about a different car, the 2011 Volkswagen CC, 2010 Volkswagen CC, and 2009 Volkswagen CC. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Calibration Tool For Lane Changing Assist VAS 6350
After performing service work on the vehicle, it may be necessary to calibrate the rear view camera system anew. In detail, this is the case after:
- removing and installing rear view camera
- replacing the rearview camera system control module
- after repair work performed on rear lid following an accident
- the standing height of one axle changes by more than 5 mm
- the standing height of the entire vehicle changes by more than 10 mm.
There is some work, which must be performed, before performing the actual calibration. Use the Vehicle Diagnostic Tester as described in the following.