Battery, Transmitter And Receiver Unit, Fuse And Wiring Harness, Overview

WARNING: This page is about a different car, the 2011 Volkswagen CC, 2010 Volkswagen CC, and 2009 Volkswagen CC. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Battery, Transmitter/Receiver Unit - Fuse And Wiring Harness, Overview

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Positive Connection
- Red wire with suitable connection.
To Terminal 15a
- Connection to terminal 15a, refer to SYSTEM WIRING DIAGRAM.
- Ensure wire is protected by fuse.
- Fuse maximum 15 amps
Antenna Ground
- Ensure correct ground connection to body.
- Antenna location must be treated with suitable corrosion protection.
Transmitting/Receiving Antenna
- Installation locations, refer to TRANSMITTED OUTPUT, ANTENNA INSTALLATION LOCATIONS .
Shielded Antenna Wire
- Wire with coaxial connector.
Telephone Or Two-Way Radio Transmitter/Receiver Unit
Wiring Harness
- Voltage supply positive via red wire, 2.5 mm² cross section.
- Voltage supply negative via brown wire, 2.5 mm² cross section.
- If necessary, wire to terminal 15a via black wire 1.5 mm ² cross section.
Fuse Holder
- Attach next to the battery.
To Starter
Battery
- Installation location in engine compartment.
Negative Wire
Body Ground