LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2014 >> Beetle TDI, 2D Hatchback, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> 2.0L - Generic Scan Tool - Engine Code: CJAA (Hatchback) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Procedures >> Fuel Pump 2 In-Line / Fuel Pump Relay 2, Checking >> Checking Activation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Checking Activation

-- Switch the ignition ON.

-- Using a Multimeter, Check the Fuel Pump Relay 2 -J49- electrical harness connector terminals 1 and 2 for voltage.

Specified value: Battery Voltage

-- Switch the ignition Off.

If the specified value was obtained:

-- Replace the Fuel Pump Relay 2 -J49- and retest for operation.

If the specified value was Not obtained:

-- Remove the Engine Control Module (ECM) - J623-. Refer to appropriate service information.

-- Using a Multimeter, Check the Fuel Pump Relay 2 -J49- electrical harness connector to the Engine Control Module (ECM) - J623- electrical harness connector T60 for an open circuit.

Fuel Pump Relay 2 -J49- electrical harness connector terminals Engine Control Module (ECM) - J623- electrical harness connector T60 terminals.
2 15

Specified value: 1.5 Ω Max.

If the specified value was Not obtained:

-- Check the wiring connection for an open circuit, short circuit to Battery positive or Ground

-- Check the wiring connection for damage, corrosion, loose or broken terminals.

-- If necessary, repair the faulty wiring connection.

-- Go to FINAL PROCEDURES 

If the specified value was obtained:

-- Replace the Engine Control Module -J623-. Refer to appropriate service information.

scientia non olet · About LEMON Manuals