Cell Phone Operating Electronics Control Module -J412-, UMI: Removing

WARNING: This page is about a different variant/trim than selected.

-- Switch off the ignition and all electrical consumers and remove the ignition key.

-- Disconnect any devices connected to the Cell Phone Operating Electronics Control Module -J412-.

-- Remove the glove compartment. Refer to Removal and Installation .

-- Release and disconnect the connector from the Cell Phone Operating Electronics Control Module -J412-.

-- Remove the screws -3- and remove the Cell Phone Operating Electronics Control Module -J412- -1- with the bracket -2-.

Fig 1: Identifying Cell Phone Operating Electronics Control Module

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bracket -2- from the Cell Phone Operating Electronics Control Module -J412- -1-.