LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2014 >> Beetle TDI, 2D Hatchback, Automatic DCT Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> 2.0L - Generic Scan Tool - Engine Code: CJAA (Hatchback) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Procedures >> Fuel Pump 2 In-Line / Fuel Pump Relay 2, Checking >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

-- Perform a preliminary check to verify the customers complaint. Refer to PRELIMINARY CHECK 

Start diagnosis

Make sure the engine is at room temperature.

-- Disconnect the Fuel Pump Relay 2 -J49- electrical harness connector. Refer to applicable wiring diagram for proper relay location.

-- Switch the ignition ON.

-- Using a Multimeter, Check the Fuel Pump Relay 2 -J49- electrical harness connector terminals 1 and 3 to Engine ground, for voltage.

Specified value: Battery Voltage

-- Switch the ignition Off.

Continue test according to the following table:

Value Cause Test
If the specified value was not obtained: Open or shorted circuit Checking Wiring 
If the specified value was obtained: Check reference signal circuit Checking Activation 
scientia non olet · About LEMON Manuals