2.5L - Generic Scan Tool - Engine Code(S): CBTA & CBUA (Convertible)

• St Generic Scan Tool
  • General Information
    • Notes
    • Safety Precautions
    • Clean Working Conditions
    • On Board Diagnostic Systems
    • Malfunction Indicator Lamp Illumination
    • Controller Area Network Data Link
    • Electronic Power Control Warning Lamp
  • Description And Operation
    • Notes
    • Fuel Supply System
    • Evaporative Emission System
    • Electronic Engine Power Control
    • Fuel Injection System
    • Engine Control Module
    • Exhaust System Components
    • Secondary Air Injection System
    • Ignition System
    • Automatic Transmission
  • Diagnosis And Testing
    • Preliminary Check
    • Readiness Code
      • Notes
      • Test Requirements
      • Drive Cycle Procedure
    • Diagnostic Modes 01 - 09
      • Notes
      • Diagnostic Mode 01 - Read Current System Data
        • Notes
        • Test Requirement
        • Procedure
      • Diagnostic Mode 02 - Read Operating Conditions
        • Notes
        • Procedure
      • Diagnostic Mode 03 - Read DTC Memory
        • Notes
        • P-Codes
        • U-Codes
        • Procedure
      • Diagnostic Mode 04 - Erase DTC Memory
        • Notes
        • Procedure
      • Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions
        • Notes
        • Test Requirements
        • Work Procedure
        • Monitor-ID 01: Oxygen Sensor Monitor Bank 1 - Sensor 1
        • Monitor-ID 02: Oxygen Sensor Monitor Bank 1 - Sensor 2
        • Monitor-ID 03: Oxygen Sensor Monitor Bank 1- Sensor 3 (CBUA Only)
        • Monitor-ID 21: Oxygen Storage Content of Catalyst
        • Monitor-ID 35: Variable Valve Timing Monitor
        • Monitor-ID 3B: Fuel Tank EVAP System Integrity/Leak Test (0.40)
        • Monitor-ID 3C: Fuel Tank EVAP System Integrity/Small Leak Test (0.20)
        • Monitor-ID 3D: EVAP Purge Flow Monitor
        • Monitor-ID 41: Oxygen Sensor Heater Monitor Bank 1 - Sensor 1
        • Monitor-ID 42: Oxygen Sensor Heater Monitor Bank 1 - Sensor 2
        • Monitor-ID 43: Oxygen Sensor Heater Monitor Bank 1 - Sensor 3 (CBUA Only)
        • Monitor-ID 71: Secondary Air Monitor (CBUA Only)
        • Monitor-ID A2: Misfire Cylinder 1 Data
        • Monitor-ID A3: Mis-Fire Cylinder 2 Data
        • Monitor-ID A4: Mis-Fire Cylinder 3 Data
        • Monitor-ID A5: Mis-Fire Cylinder 4 Data
        • Monitor-ID A6: Mis-Fire Cylinder 5 Data
      • Diagnostic Mode 07 - Read Faults Detected During The Current Or Last Driving Cycle
        • Notes
        • Procedure
      • Diagnostic Mode 08 - Request Control Of On-Board System, Test Or Component
      • Diagnostic Mode 09 - Read Vehicle Information
        • Notes
        • Test Requirement
        • Procedure
    • Engine DTC Tables
      • Notes
      • Engine Control Module
    • Transmission DTC Tables
      • Notes
      • Transmission Control Module --, 09G
        • Notes
        • Footnote
    • Diagnostic Procedures
      • Fuel Pump Voltage Supply, Checking
        • Notes
        • Test Conditions
        • Test Procedure
        • Final Procedures
      • Fuel Pump Pressure, Checking
        • Notes
        • Test Conditions
        • Test Procedure
        • Final Procedures
      • Fuel Pump Delivery Rate, Checking
        • Notes
        • Test Conditions
        • Test Procedure
        • Final Procedures
      • EVAP System, Checking For Leaks
      • EVAP Purge Regulator Valve, Checking
        • Notes
        • Test Requirements
        • Test Procedure
        • Final Procedures
      • Leak Detection Pump, Checking
        • Notes
        • Test Requirements
        • Test Procedure
        • Checking Wiring
        • Final Procedures
      • Accelerator Pedal Position Sensor -G79- /Accelerator Pedal Position Sensor 2 -G185-, CHECKING
        • Function
        • Test Requirements
        • Test Procedure
      • Throttle Valve Control Module -J338-, CHECKING
        • Function
        • Test Requirements
        • Test Procedure
      • Oxygen Sensor Before Catalytic Converter, Checking
        • Notes
        • Test Requirements
        • Test Procedure
        • Checking Wiring
        • Final Procedures
      • Heated Oxygen Sensor -G39-, CHECKING HEATER
        • Notes
        • Test Requirements
        • Test Procedure
        • Final Procedures
      • Oxygen Sensor In Center Catalytic Converter, Checking (CBUA Only)
        • Notes
        • Test Requirements
        • Test Procedure
        • Checking Wiring
        • Final Procedures
      • Oxygen Sensor In Bank 1 Center Three Way Catalytic Converter -G465-, CHECKING HEATER
        • Notes
        • Test Requirements
        • Test Procedure
        • Final Procedures
      • Oxygen Sensor After Three Way Catalytic Converter -G130-, CHECKING
        • Notes
        • Test Requirements
        • Test Procedure
        • Checking Wiring
        • Final Procedures
      • Oxygen Sensor After Three Way Catalytic Converter -G130-, CHECKING HEATER
        • Notes
        • Test Requirements
        • Test Procedure
        • Final Procedures
      • Manifold Absolute Pressure Sensor -G71-, CHECKING
        • Function
        • Test Requirements
        • Test Procedure
      • Engine Coolant Temperature Sensor -G62- / Engine Coolant Temperature Sensor On Radiator Outlet -G83-, CHECKING
        • Notes
        • Test Requirements
        • Test Procedure
        • Testing if display is approx. - 40.0°C
        • Testing if display approx. 140.0°C
        • Final Procedures
      • Outside Air Temperature Sensor -G17-, CHECKING
        • Notes
        • Test Procedure
        • Checking Wiring
        • Final Procedures
      • Manifold Absolute Pressure Sensor -G71- / Intake Air Temperature Sensor -G42-, CHECKING
        • Function
        • Test Requirements
        • Test Procedure
      • Engine Speed Sensor -G28-, CHECKING
        • Function
        • Test Requirements
        • Test Procedure
      • Fuel Injectors, Checking
        • Notes
        • Test Requirements
        • Test Procedure
        • Final Procedures
      • ECM Voltage Supply, Checking
        • Notes
        • Test Requirements
        • Test Procedure
        • Final Procedures
      • Catalytic Converter, Checking
        • Test Requirements
        • Function Test
        • Final Procedures
      • Secondary Air Injection Combination Valve, Checking
        • Notes
        • Test Conditions
        • Test Procedure
        • Final Procedures
      • Secondary Air Injection Pump Motor -V101-, CHECKING
        • Notes
        • Test Requirements
        • Test Procedure
        • Final Procedures
      • Secondary Air Injection Pump Relay -J299-, CHECKING
        • Notes
        • Test Requirements
        • Test Procedure
        • Checking Wiring
        • Final Procedures
      • Secondary Air Injection Solenoid Valve -N112-, CHECKING
        • Notes
        • Test Requirements
        • Test Procedure
        • Checking Wiring
        • Final Procedures
      • Secondary Air Injection Sensor 1 -G609-, CHECKING
        • Function
        • Test Requirements
        • Test Procedure
      • Camshaft Position Sensor -G40-, CHECKING
        • Function
        • Test Requirements
        • Test Procedure
      • Camshaft Adjustment Valve 1 -N205-, CHECKING
        • Notes
        • Test Requirements
        • Test Procedure
        • Checking Wiring
        • Final Procedures
      • Knock Sensor 1 -G61- / Knock Sensor 2 -G66-, CHECKING
        • Notes
        • Test Requirements
        • Test Procedure
        • Checking Wiring
        • Final Procedures
      • Ignition Coil With Power Output Stage, Checking
        • Notes
        • Function
        • Test Requirements
        • Test Procedure
      • Speed Signal, Checking
        • Notes
        • Test Requirements
        • Test Procedure
        • Final Procedures
      • Can Bus Terminal Resistance, Checking
        • Notes
        • Test Requirement
        • Function
        • Test Procedure
        • Checking Wiring
        • Final Procedures
      • Can-Bus Terminal Resistance, Transmission Control Module To Engine Control Module, Checking
        • Notes
        • Test Requirement
        • Test Procedure
        • Final Procedures