Vehicle Electrical System Control Module - J519-, Output Diagnostic Test Mode

The following components can be checked with vehicle electrical system control module Output DTM:

Right Low Beam Headlamp -M31-, for vehicles with gas-discharge lamps Right Hid Headlamp Bulb -L14-
Right High Beam Headlamp Bulb -M32-, on vehicles with HID headlamp bulbs Right Headlamp Reflector Adjustment Solenoid -N396-
Left Low Beam Headlamp -M29-, for vehicles with gas-discharge lamps Left Hid Headlamp Bulb -L13-
Left High Beam Headlamp Bulb -M30-, on vehicles with HID headlamp bulbs Left Headlamp Reflector Adjustment Solenoid -N395-
Left Position Lamp Bulb -M1-
Right Position Lamp Bulb -M3-
Left Front Turn Signal Bulb -M5- and Left Rear Turn Signal Bulb -M6-
Right Front Turn Signal Bulb -M7- and Right Rear Turn Signal Bulb -M8-
Left Front Fog Lamp Bulb -L22- and Right Front Fog Lamp Bulb -L23-
Only in vehicles with gas-discharge lamps Right High Beam Headlamp -M32- and Left High Beam Headlamp -M30-
Headlamp Washer Relay -J39- and Headlamp Washer Pump -V11-
Emergency Flasher Indicator Lamp -K6-
High Tone Horn -H2- and Low Tone Horn -H7-
Left Front Footwell Illumination Bulb -L151-, Right Front Footwell Illumination Bulb -L152-, Left Rear Footwell Illumination Bulb -L106- and Right Rear Footwell Illumination Bulb -L107-
Windshield And Rear Window Washer Pump -V59-
Seat heating release
Supply Rain/Light Recognition Sensor -G397-
Emergency start signal

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER .

-- In the Vehicle Diagnostic Tester, select "guided fault finding".

-- Using the "Go to" button, select the "function/component selection" and the following menu options in sequence: